User Manual

Technical principles of operation

To make the process of percolation takes to prepare an Italian espresso takes two elements: hot water and pressure.

Makèspresso is an Italian espresso machine based on an innovative technical concept.
The pressure required to make the percolation of water is obtained without using pumps or electric boilers but exploiting the pressure of a CO2 cartridge standard for food use.

Makèspresso can be used in two modes:
1) By directly entering hot water (so without the aid of electricity)
2) heating the water with the heating resistor integrated low voltage (12V).

The resistance can be electrically powered in 2 ways:
- From a cigarette lighter socket using the supplied cable (for use on motor vehicles).
- With the power supply / transformer supplied via an electrical outlet with voltage 110-120V / 220-240V (for home use or in the workplace).

General safety instructions

1. The device is not intended for use by persons (including children) with reduced physical, sensory or mental capacities, or lack of experience or knowledge, unless they have been given, through the intermediary of a person responsible for their safety, of supervision or instruction concerning use of the appliance.

2. Keep out of reach of children and pets. In particular, children should be supervised to ensure that they do not play with the appliance.

3. If the unit is connected to a mains power supply do not touch with wet hands and / or metal objects, do not immerse in water or other liquids.

4. To prepare the coffee should be used only drinking water. The use of different substances may cause health risks.

5. Use only universal ESE coffee pods 44mm.

6. Do not pull or step on power cords.

7. Use only CO2 cylinders for food use.

8. If the equipment breaks down or appears damaged, do not try to repair it.

9. Do not place it near sources of heat or in direct sunlight.

Endowment and Composition of the Product

ENDOWMENT PRODUCT

1 camera body makèspresso
3 CO2 cylinders (each cylinder can deliver 15-16 coffee)
1 support "deskholder" to use makèspresso on a support surface
1 support "autoholder" to place the port makèspresso drinks of a motor vehicle
1 cable with 12V car cigarette lighter plug
1 power supply / transformer with cable outlet 110-120V / 220-240V
1 briefcase transport kit

PRODUCT COMPOSITION

A. Cover Dispenser
B. Rubber seal seat pod
C. Camera body
D. Handle grip
E. CO2 cylinder
F. Accessory support "Deskholder"
G. Accessory support "car holder"

 

Instructions for use

The preparation of espresso coffee may be performed in "deskholder" using the appropriate support metal rod (f) and in "hand" holding the device in his hand and taking advantage of the accessory "autoholder" (h). It is also possible to prepare the coffee with or without the use of electric current.

INSTALLATION / REPLACEMENT CYLINDER CO2

Before you can use the machine must be properly inserted in the CO2 cylinder:
1. Hold the camera body and screwed into place the CO2 cartridge.
2. Put the handle grip on the bottle and screw.
The CO2 cylinder is inserted in the first use and replaced once exhausted to charge (after about 15-16 coffee).

Maintenance, custody and disposal

CLEANING
The removable parts such as: dispensing cap (a), rubber seal (b) can be rinsed with water.
To clean the outer parts of the body (c) ensure that the device is not connected to a power outlet and use a soft cloth slightly damp.
Do not try to clean the internal parts of the body (c) with liquid or immersing in water.

MAINTENANCE
Not groped in any way to adjust the product in case of breakage. In case of failure if the product is under warranty please contact the manufacturer or replace.

HOUSING
Keep away from children and from heat. Do not leave it exposed in full sun.

DISPOSAL
The speaker is not an undifferentiated waste. In accordance with the European Directive 2002/96 / EC as amended, must be disposed of through the appropriate collection centers or returning it to the dealer when purchasing a new product.

  • Wugim International Co. Ltd
  • This email address is being protected from spambots. You need JavaScript enabled to view it.
  • #

Log In

fb iconLog in with Facebook

This site uses cookies technicians and own and third-party profiling for its functionality and to send you advertising and services in line with your preferences. If you want to know more click here.
By closing this banner, scrolling through this page or by clicking any element its consent to the use of cookies.